Hi! When I tried to load my own IR (Ownhammer 412) into banks 2 and 3 (the first bank is bank 0), the IR did not work and the sound came from directly out of the amp. Only the factory IR worked for it. I followed the manual and video instructions and did not delete the “preset.pan” file. The screen cut of my own IR loaded into the PL-IR is provided.
Hey Justin,
This usually indicates an issue with the IR file. Previous PL-IR owners have solved this problem by removing any metadata attached to the IR file.
What is length, bit depth and sample rate of the file?
Regards,
Dan
Hi Dan:
The length of my IR file is 0.2 seconds (61 KB), the sample rate is 96 kHz and the Bits per sample is 24.
Best,
Justin
Hi Justin
Can you check the same rate of the Fryette IRs? Match that, I’m not sure if 96kHz is supported, it might me.
Regards
Dan
Hi Dan:
The Fryette IRs are in 48khz, that might be the reason, I will try my other IRs with 48khz. The ones with 44.1 and 96khz did not work. Does PL_IR only support 48khz?
Best,
Justin
I’m pretty sure it only supports 48kHz at 24-bit, 20ms max. (smaller is fine).
So sounds like you are running up against the metadata issue or the file is corrupted somehow? Happy to take a look if you want to post it or PM me. However I don’t have a PL-IR (yet!) but I can take a look at the file.
Regards
Dan
This is my custom 48khz, 24 bit depth IR. I can load it to my DAW using line6 helix plugin, so I think it is not corrupted. Thank you!
Best,
Justin