PS-100 Line Out and Cyclops

Stage & Studio Cyclops
1

Hi Folks,

I’m looking for some help please.

I currently use a PS-100 with a UA OX Stomp (cab sim pedal) connected to the line out, which then connects to either my DAW or a Boss RC600 looper.

There’s a KHE switcher and a bunch of amps and cabs involved as well but I don’t think they matter for my question.

I’m intending to add a Cyclops to the setup so that I can connect preamp pedals, in addition to the amps via the KHE switcher and amplify them via the PS-100. Their signal can then be routed to any of my cabs. This bit seems easy enough as KHE provide doco explaining how to hook this up!

However from the hookup diagram in the Cyclops manual it shows the PS-100 line out connects to the Cyclops and therefore I have nowhere to “tap” the output for the OX Stomp.

Is there any way to achieve this or am I out of luck?

Thanks

2

Hmm, now that I’ve looked at the back of the PS-100 properly :upside_down_face:, I see I also have the balanced line out (xlr) jack. So, I assume I can use that to connect to the OX Stomp while simultaneously using the 6.5mm line out jack for the Cyclops. Is that right?

3

Hi !

Yes you can use both at the same time :slight_smile:

Regards,

Dan