Hey Guys. Been running a WDW rig for a long time with the PS2. Main amp is dry but uses the attenuator, Slo-100 is somewhat loud each side has a 2x12 for effect. Out of the PS-2’s LINE out, i have a cable going to my pedalboard first pedal IN, then last one in stereo goes to a ROCKTON Velocity 300 for the output going to the 2 side cabs. Now, this morning was reheasing when suddenly it all went silent except my main amp, which the volume suddenly dropped.
Amp is fine on its own, Rocktron as well. The PS-2 does’nt seem to have anything coming out of LINE out and the attenuator seems to just lower my amp’s volume even with the attenuator active or not. I changed but power tube and 12ax7 and same thing.
First, unplug everything from the PS2, no effect loop, etc. You just want your guitar, your amp the PS2 and a the speaker.
Does the PS2 sound good in both bypass and operate mode?
Try putting the toggles into flat; does that make any difference?
Now test the lineout; how is the signal level? Make sure the level switches are selected correctly too (the little push buttons on the front and back panel).
did all those test and noticed a few other things. When i click the Ground Lift button, major sound level drop. When using the PS-2 like i have been for a while, i can barely get a signal from the line out and need to raise the VOLUME of the atternatuator to crank the amp even if the amp’s volume is cranked to 8. I was told its a know issue but not more then that.
Did changing the toggles to flat make any difference?
The line out is passive. So this means one of four things:
The signal going in from your amp is tiny
The level switches for amp input or line level output or line out volume are set incorrectly
You have a low impedance connected to the line out
Something is broken in the PS between your amp’s input and the line out — this will need a service to fix.
So I need some more detail from you.
Use bypass mode to confirm you have loud signal from your amp to speaker
Confirm your signal is loud when in operate mode by matching the volume to bypass mode with the power station.
Please confirm and tell me how you level switches are set and how the line out volume control is set, post photos
Can you tell me exactly what the line out is connected to: the device and the label on the jack socket and if you really want to put a smile on my face: find the page in the user manual that describes that input and post it here.
With this information we might be able to fix it or arrange a service.
each side has a 2x12 for effect. Out of the PS-2’s LINE out, i have a cable going to my pedalboard first pedal IN, then last one in stereo goes to a ROCKTON Velocity 300 for the output going to the 2 side cabs. Now, this morning was reheasing when suddenly it all went silent except my main amp, which the volume suddenly dropped.
